Quantum Audio DAT72 Guide de l'utilisateur télécharger pdf (Page 67)

Chapter 5 Understanding the Drive LEDs

Drive LED

DDS-4/DAT 72 User’s Guide 53

Table 11 Drive LED

LED Status Description

ON continuously The drive is reading or writing the tape (SCSI or

tape movement is present).

Flashing rapidly A hardware fault occurred. If the fault occurs

immediately after powering on the drive, the

Power-On Self-Test switch (switch 4) is enabled

and a Power-On Self-Test has failed. If the front

panel LEDs are flashing together, contact the

Technical Support department.

If the Drive LED is flashing rapidly during drive

operation, press the Eject button to remove the

tape. If the tape does not eject within 2 minutes,

press and hold the Eject button for more than 5

seconds. The tape should eject within 40 seconds.

Contact Technical Support for more information.

Note: If your backup software issues a SCSI

Prevent Media Removal

command, the

Drive LED remains ON and the Eject button is

disabled, so that the tape cannot be ejected accidentally. To

eject the tape, use your backup software’s

Eject command.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 83 84

Pas de commentaire

Quantum Audio DAT72 Guide de l'utilisateur Page 67